finish montage but screen off
Ended assembly, light on in block but nothing on the screen LCD
Is this a good question?
please check the electronics again (Chapter 8), the PSU connection might be loose and the same goes for the LCD cables.
You can also try connecting your computer using the USB cable (included in the kit) and try operating the printer using software Pronterface (in the driver package).
If nothing mentioned above works, please contact our live chat support at https://shop.prusa3d.com/en/
Was this answer helpful?
Past 24 Hours: 2
Past 7 Days: 10
Past 30 Days: 23
All Time: 23