Can't remove model that came on prebuilt model

I purchased an i3 MK2 prebuilt model. It came with a 3D PRUSA logo on the heatbed. I cannot get it to come off? Is it supposed to come off? If I run the V2calibration.gcode file it returns an error when the nozzle hits the 3D logo. Any guidance would be appreciated.

Block Image

Block Image

Answer this question I have this problem too

Is this a good question?

Score 0
Add a comment

1 Answer

The folks at Prusa emailed me and said it was alright to use a metal spatula. I did and it worked great. Those prints really stick to the heat bed so my suggestion would be to go out and purchase a small metal spatula. thank you.

Was this answer helpful?

Score 0
Add a comment

Add your answer

Randy White will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 49