Are my extruder nozzle wires supposed to look like this?

Block Image

I just received my printer kit yesterday and began putting it together. I just got to the extruder assembly and saw that the wires looked like the picture above. This doesn't seem like this is how it's supposed to look. The wires were not wrapped as displayed and I'm wondering if I need to get a replacement part or if I'm just overreacting.

Answer this question I have this problem too

Is this a good question?

Score 0
Add a comment

1 Answer

Mine looks like this too. Don't worry about that. The outer wrap can move along the wire. Just push it against the heating element before tightening the wire with ziptie.

Was this answer helpful?

Score 0
Add a comment

Add your answer

Derek Konyshak will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 1

All Time: 108