All you need to build a Prusa i3 1.75 kit. You can buy the original at Shop.Prusa3D.com

13 Questions View all

Lost my rambo for prusa

I lost my Rambo, can I replace with my own sourced rambo/arduino+ramps

And where can I find the programme to upload on it

Answer this question I have this problem too

Is this a good question?

Score 0
Add a comment

1 Answer

You may place an order directly from Prusa, it might be backordered for some time, but you can try to ask for teh delivery date.

http://shop.prusa3d.com/en/electronics/4...

Was this answer helpful?

Score 0

Comments:

Hi thanks for that! However It might take months and months before i could print again. Cant I just source the board myself and upload the config? If yes, where might I find the config

by

Maybe this one.

I hope this is the right layout.

https://ultimachine.com/products/mini-ra...

The firmware is there:

http://www.prusa3d.com/drivers/

by

Add a comment

Add your answer

Revanth will be eternally grateful.
View Statistics:

Past 24 Hours: 1

Past 7 Days: 1

Past 30 Days: 2

All Time: 57