P.I.N.D.A. Probe mounting issue

I was putting together my recently received prusa I3 mk2 and I was about to mount the probe but the mounting bracket was different than any of the manuals it looks like it uses 2 bolts and 2 square m3 nuts but what length bolts do I use?

Answer this question I have this problem too

Is this a good question?

Score 1
Add a comment

2 Answers

Most Helpful Answer

I had the same issue with a replacement part I was sent.

I believe they have updated the mounting for the PINDA probe on the extruder body but haven't updated the assembly instructions.

You need 10mm length M3 bolts.

Was this answer helpful?

Score 1
Add a comment

There is an update to MK2 design regarding P.I.N.D.A. mounting bracket, see Chapter 5, Step 20

5. Extruder Assembly

When finished, head to Chapter 9 to adjust sensor height correctly:

9. Preflight check

Let me know, if it helped ;)

Original Prusa i3 MK2S kit assembly Image

Guide

5. Extruder Assembly

Difficulty: Moderate1 - 2 hours

Original Prusa i3 MK2S kit assembly Image

Guide

9. Preflight check

Difficulty: Moderate25 minutes

Was this answer helpful?

Score 0
Add a comment

Add your answer

Justin will be eternally grateful.
View Statistics:

Past 24 Hours: 1

Past 7 Days: 6

Past 30 Days: 41

All Time: 245