Bed leveling failed, sensor disconnected or cable broken.

This happens when I try and calibrate the "mesh bed levelling"

Answer this question I have this problem too

Is this a good question?

Score 0

Comments:

I know this means i don't have the PINDA probe connected but I have checked and is in the correct location and orientation therefore is the probe or cable for it broken?

by

Add a comment

1 Answer

Most Helpful Answer

Hi,

Do the red light on the top of the PINDA probe blink when it approach the bed ?

Was this answer helpful?

Score 1

Comments:

Okay this issue was resolved, but I have now run into another one.

by

Add a comment

Add your answer

Tomás A will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 3

Past 30 Days: 7

All Time: 95