XYZ calibration crashes into bed on point 4 (right side, middle point)

My PINDA is working (red light switches on and off)

I'm starting XYZ calibration, first 4 points with paper go fine, but when improving calibration points starts, the first front 3 points of improving calibration go fine, but when it reaches point 4, it crashes deeply in my bed. The right side middle point.

What steps should I try to fix this?

Answer this question I have this problem too

Is this a good question?

Score 1
Add a comment

2 Answers

Lower the PINTA. It solves my issue.

Was this answer helpful?

Score 0
Add a comment

Hi,

"XYZ calibration" is different from "Z adjust". With XYZ calibration, the printer only check that the probe "see" the bed. So you need to lower the probe and the nozzle will not crash on the bed. Run the calibration and wait for the result.

When everything is correct after XYZ calibration test, then put the paper sheet on the bed (cold of course) and play with Z adjust until you can move the sheet a little. It's important that you're still able to move the sheet...

enjoy !

Was this answer helpful?

Score 0
Add a comment

Add your answer

Ruxviii will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 2

All Time: 86