Original Prusa i3 MK2S is a successor to Original Prusa i3 MK2 with small hardware tweaks for easier assembly and improved reliability.

25 Questions View all
Question Closed

Message "Distance between tip of the nozzle and the bed surface...

Each time I open the printer there is this message. What do I have to do to remove it.

Distance between tip of the nozzle and the the bed surface has not been set yet.

Please follow the manual, chapter First steps, section First Layer calibration.

I already did all the calibration options yesterday with sucess. (including the level adjust Z option).

Answer this question I have this problem too

Is this a good question?

Score 2
Add a comment

2 Answers

Hi,

go to : calibration > mesh bed leveling and run it. Wait and see the result.

Was this answer helpful?

Score 0

Comments:

Ran mesh bed leveling. completed normally. Same message comes up on restart.

by

Add a comment

Hi Isabelle,

did you print the V2 Calibration code?

Was this answer helpful?

Score 0
Add a comment
View Statistics:

Past 24 Hours: 0

Past 7 Days: 11

Past 30 Days: 176

All Time: 506