Original Prusa i3 MK2S is a successor to Original Prusa i3 MK2 with small hardware tweaks for easier assembly and improved reliability.

25 Questions View all

Right Z axis rod jamming half way.

hey guys, ive just finished putting my i3 mk2s kit together, and when i was putting on the black plastic screws to hold the Z axis to the threaded rods i noticed the right one was stiff about half way down, but by hand i could twist it past that point.

so now come to the self test stage and moving the Z axis from the bottom to the top using the settings, once again the right side is stopping half way while the left side runs smoothly.

i have tried...

- lubing the rod.

- switching the black clips over from left to right (thinking it was the clip) but still the right rod gets jammed.

- without the black clip on the right side..... and it goes up but only because there is no thread around the rod.

i believe the rod is faulty, thats all i can put it down to. ( at the point of jamming the rod thread doesn't look right)

can anyone help me with this? or know who i can speak to, to get a replacement part shipped over.

thank you michael.

Answered! View the answer I have this problem too

Is this a good question?

Score 0
Add a comment

1 Answer

Chosen Solution

Hi Michael,

please send an email including description, photos/video to info@prusa3d.com, if you have a faulty part, you will get a replacement.

When your issue is solved, please mark this answer as the solution.

Thank you

Jakub

Was this answer helpful?

Score 0
Add a comment

Add your answer

Michael Bitzilis will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 1

All Time: 22