Replace hotend thermistor replacement process?

I have a replacement thermistor for the hotend. I have been through diagnosis via email with support and the thermistor is not working (after I had to remove the hot end to fix a bad clog).

Overall, I need instructions on how to properly replace the hotend thermistor.

Thank you in advance.

---

Are there any instructions on how to replace a thermistor properly ... I am afraid I might screw up something else!

Answer this question I have this problem too

Is this a good question?

Score 0

Comments:

Sorry, I get:

403

FORBIDDEN ACCESS - PRUSA3D

You cannot view this guide.

I look forward to checking this guide out!

by

Oh sorry, it was locked.

by

Add a comment

2 Answers

Hi Jack,

there is no guide for thermistor replacement, but I will try my best to do it asap.

Was this answer helpful?

Score 0
Add a comment

Hi Jack,

here is the manual I promised ;)

How to replace thermistor in the Extruder

Was this answer helpful?

Score 0

Comments:

I will be get back to doing this tomorrow. Sorry for the delay, and thank you for the effort.

by

Hi Jack, no problem at all. I'm busy as well. Just please mark the answer as a solution for the other users. Thanks

by

Add a comment

Add your answer

Jack Coats will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 17

Past 30 Days: 37

All Time: 37