exturder and heat bed fight for power and never gets hot
exturder and heat bed fight for power and never gets hot so the printer will'nt start
Is this a good question?
I need more info about your situation:
1) What printer do you have?
2) Did you build yourself or it was assembled by us?
3) What filament do you want to print from?
4) What model do you want to print?
5) What is the temperature in the room?
6) Is there any draft (blowing wind) in the room?
Let me know ;)
Was this answer helpful?
Past 24 Hours: 0
Past 7 Days: 0
Past 30 Days: 3
All Time: 3