My extruder head is blocked just above the alu block

My extruder head is blocked just above the alu block.

two questions:

- Is there anything at that place what should be there or should there be a channel of 1.75 mm all the way from the top of the print head to the print mouth? or is it a problem when a push a metal wire through the compleet head?

- can the alu block be separated from it's cooling fins?

Answer this question I have this problem too

Is this a good question?

Score 0
Add a comment

1 Answer

Hi,

to answer your questions:

1) There a PTFE tube through the heatsink. You can try to increase temperature to 260-270 and try to push ABS through. Or heat it up to 290 and carefully push a metal wire through.

2) Block and cooling fins are one part, but the whole Hotend can be disassembled. Guide for this is coming up soon.

Was this answer helpful?

Score 0
Add a comment

Add your answer

Y. Braaksma will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 12

All Time: 15