XYZ Calibration fails before beginning.
Originally I was able to make it through the first process of xyz calibration, but as soon as it moved on to "improving accuracy" in the second step of xyz calibration, the extruder stabs a little hole in the paper and would catch so I slightly lowered the PINDA probe.
Then it wouldn't even start xyz calibration. The z-axis would raise completely, it would ask if the steel sheet was removed and if the nozzle was clean, then it would immediately fail the calibration before starting anything. I slightly tightened the trapezoidal screws on the z-axis, and now the printer asks if the steel sheet was removed, moves the z-axis downward and fails and soon as it brings the extruder to it's position close to the bed. I attached a link to a video to show the process.
I've updated the firmware as well. Thanks!
EDIT: Important note, I was able to make it past this step BEFORE I updated the firmware to the latest version.
Is this a good question?