Image 1/2: First apply two coats of 3D print glue. Image 2/2: Now you are ready to print PLA. Coat should last a long time if you don't touch the printbed with hands. Reapply as needed.
  • We use regular glass 20x21cm 2mm thick. Before you start; clean it.

  • First apply two coats of 3D print glue.

  • Now you are ready to print PLA. Coat should last a long time if you don't touch the printbed with hands. Reapply as needed.

  • Printbed comes already coated from us, so you are ready to print.

Add Comment

Image 1/2: Lightly spray the printbed with the supplied bottle on already dried glue. Image 2/2: This can last for couple of prints, but every print decreases the stickiness.
  • For printing ABS and PET you need to apply second coat with our ABS Juice.

  • Lightly spray the printbed with the supplied bottle on already dried glue.

  • This can last for couple of prints, but every print decreases the stickiness.

  • You don't need to reapply the glue before every print. Just Juice ;-)

Step 3. Clip the glass onto the heatbed.

pgiustino - Reply

Can you please post the formula for the ABS juice if I'm using 1.75mm filament? I ruined the label on my container the first time I filled it. :(

DiddyWolf - Reply

Finish Line

34 other people completed this guide.

Josef Prusa

Member since: 01/05/2015

37,672 Reputation

88 Guides authored

Team

Prusa Research Member of Prusa Research

Community

1 Member

88 Guides authored

0 Comments

Add Comment