Message "Distance between tip of the nozzle and the bed surface...Each time I open the printer there is this message. What do I have to do to remove it. Distance between tip of the nozzle and...
No light open on the bed and error messageWhen I connect to Pronterface there is the error message. Error:Temperature heated bed switched off. MINTEMP triggered ! [ERR...
Answer to: No light open on the bed and error messageFinally, the problem was the thermistor. Once I changed it, it works again.
Answer to: XYZ calibration crashes into bed on point 4 (right side, middle point)Lower the PINTA. It solves my issue.