Answer to: loads fine ejects when printingHi, I am facing the same issue. Can you tell me how you fixed it? Thanks!
Answer to: Ekstruder running the wrong way.Hello, I am facing the same issue with my Prusa Superswitch MK3. I followed the recommended steps: 1) Press the "X" button once 2) Immediately after press and hold the knob until a beep sound 3) From the menu select "All data" FW is already up to date (3.0.12) Also checked wiring between Rambo board and Super Switch. Everything looks the same as state on 4B. Electronics assembly (older version) However problem was not soved for Extruder 1 and 3. When I select Unload Filament 1/3 respective Filament is loaded instead and vice versa. Then I decided to invert polarity of Extruders 1 and 3 by changing wires of one coil and now direction is correct. So could you please confirm that there is an issue with Superswitch MK3 (wiring on PCB or SW issue)? In addition I'm facing a lot of problems with printing as sometimes no or not enough filemant is pushed out of the nozzle and one can hear respective extruder "clickering", especialy at Extruder 1 and 3. Could you also help me with my 2nd issue? Thanks a lot Best regard...