X-axis can't go all the way up the Z-axis.

The X-axis can't go all the way up the Z-axis.

The X-end-idler seems to collide with the screws from the Z-axis-top parts.

The screws of the Z-axis-top parts are all the way in (touching the plastic Z-axis-top parts).

This is preventing the X-axis from going all the way up.

Is this a problem? How should I fix this?

Answer this question I have this problem too

Is this a good question?

Score 0
Add a comment

1 Answer

Hi Koen,

please take several photos (or video) so I can check the build. Post them here.

Thank you


Was this answer helpful?

Score 0



Here's the album (5 pictures), if you require other angles please let me know.


Hi Koen, this is correct assembly. Proceed to the calibration ;)


Add a comment

Add your answer

Koen Verkaik will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 2

All Time: 148