Filament Loading on MK2S MMU

I can load filament through the menu on Extruder 1. Extruders 2, 3, and 4 all slow load correctly, but then spit the filament back out about 1/4" when I go to fast load. All wiring is double-checked. Again, Extruder 1 is working correctly. Tried flashing the firmware twice, no change.

Answer this question I have this problem too

Is this a good question?

Score 0

Comments:

I used settings... move axis... move e to feed the other 3 pla plastics all the way into the multiplexor. It took forever, but I can now print the gear 4 material sample gcode. So my big issue at this point is quick loading of new filament.

by

Add a comment

1 Answer

Hi Jacob,

Can you send me a video of this at info@prusa3d.com? That way, I will try to help you out further.

Was this answer helpful?

Score 0
Add a comment

Add your answer

Jacob Felger will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 1

All Time: 38