English manuals for Original Prusa i3 3D printers

286 Questions View all

X-axis end stop not being pushed by the moving part

I just completed the X axis according to instructions, however, the thing that moves never hits the X-stop.

Here's a video of the issue, and how I put together the axis.

Please advise..


Answer this question I have this problem too

Is this a good question?

Score 0


I'm very disappointed in the support being provided.


Add a comment

1 Answer

I would confirm that the bearing is fully seated in its seat. If so, then you have a couple of options.

1) you could use jb weld or something similar to build up the printed part so it does hit the limit switch

2) move the limit switch so it lines up with the part

3) get someone to print a new part from the original file and replace.

Was this answer helpful?

Score 0
Add a comment

Add your answer

Ognen Plavevski will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 2

All Time: 52