BVOH not printing...switches to it then switches BACK before printing.
So, I'm trying to print a part using Slic3r (1.37.1) with the Multi Material upgrade on and MK2S. I have my print filament in extruder #1 (PLA) and soluble filament in #2 (BVOH) because extruder #4 isn't working quite right.
The problem is that Slic3r preview shows the support filament in the proper places but when it goes to switch on the wipe pad it switches TWICE. It switches from 1 to 2 and then back to 1 before it starts printing. As a result, the regular PLA is printed instead of the soluble support.
Minor clarification, on 1 of 4 layers (the one with a trivial amount of support material) it actually did print the support. That is the only layer it worked on.
Let me know if you need the files.
(By the way, I would use PRUSA Control but on vertical support it prints it too close to the actual part and they fuse. As far as I can see there is no way to adjust that.)
Is this a good question?