Calibration Failure! error mssg on Z & XYZ calibration
All appears OK up to the point where it is trying to Calibrate the first point: auto Home works, goes up to top of Z-axis then when it comes down; it stops, gives error "Calibration Failure!" (Which is not listed in handbook)
Played with "move Z-axis" and it appears that the controller thinks the assembly is higher than what it is. LCD on "move Z-axis"lists lowest Z height obtainable as being 0.00. Looked in handbook, it implies to go to section "220.127.116.11 Check probe height" --- the kicker here, is that in the printed handbook supplied it stops at 18.104.22.168 and 22.214.171.124 does not exist?? I looked at the Probe response diagram, are you guys trying to say mess about with the probe height or is there something missing the handbook --- confusing as all get out.
Is this a good question?