Disappointed from the prusa multi material

After playing around with the Prusa multi material kit I can see that the probability for filament getting stuck is much higher then the single material which causes print failures

This is very disappointing and is happening for a few of my friends as well (all of which are print gurus and are sad about the quality level of this model)

Has anyone else seen the same experience?

Anyone managed to really fix this somehow?

Answer this question I have this problem too

Is this a good question?

Score 0
Add a comment

1 Answer

Hi Benny,

this site is dedicated mostly to the assembly, for troubleshooting during use I recommend talking to our support (info@prusa3d.com), or asking other members on our forum.

Was this answer helpful?

Score 0
Add a comment

Add your answer

Benny will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 4

All Time: 68