Skip to main content
  1. Versions of the MK3S manual:
    • Versions of the MK3S manual:

    • 02/2019 - Initial version 3.10

    • 03/2019 - Updated to version 3.11

    • 07/2019 - Updated to version 3.12

  2. 03/2019 - Chapter 2 (Y-axis)
    • 03/2019 - Chapter 2 (Y-axis)

    • PSU holders assembly now depends on the type of the PSU, which is in your kit.

    • 03/2019 - Chapter 7 (HB & PSU)

    • Chapter 7 is now in two versions depending on the PSU type, which is in your kit.

    • New PSU is fully black, old PSU has silver casing.

    • Manual version 3.11

  3. 05/2019 - Chapter 7 (HB & PSU)
    • 05/2019 - Chapter 7 (HB & PSU)

    • Heatbed-cable-cover design improved to prevent collision with the extruder cables, which sometimes occurred. All screws are now facing down.

    • New design with circular holes in the top part. The smaller part has hexagonal holes.

    • Old design with hexagonal holes in the top part. The smaller part has circular holes.

    • Manual version 3.11

  4. 07/2019 - Chapter 1 (Introduction)
    • 07/2019 - Chapter 1 (Introduction)

    • The printer's package contains a lubricant, which is intended for maintenance. No need to use it now the bearings are lubricated. There is a dedicated online manual on how to clean the printer and apply the lubricant. See Printer maintenance tips

    • Several tweaks and new photos across the entire manual.

    • Manual version 3.12

  5. 09/2019 - Chapter 1 (Introduction) Added warning about the ESD protection. Keep the electronics in the bag until needed for the assembly.
    • 09/2019 - Chapter 1 (Introduction)

    • Added warning about the ESD protection. Keep the electronics in the bag until needed for the assembly.

    • 09/2019 - Chapter 5 (Extruder)

    • There is a new hardware revision of the IR-sensor with some optimisations. Filament detection is the same.

    • Manual version 3.13

Finish Line

One other person completed this guide.

Dozuki System

Member since: 09/24/2009

768 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 10

All Time: 104