Skip to main content

Changes to Step #3

Edit by Dozuki System

Edit approved by Dozuki System

Deleted
Added
Unchanged

Step Lines

[title] Heatbed cable assembly (part 2) [Tłumaczenie w toku]
[* violet] Place the black wire above the pin with "GND" sign. Make sure you are using the '''rounded connector'''.
[* blue] Place the washer above the rounded cable connector.
[* green] Press the M3x10 screw through all parts.
[* black] Hold the screw and carefully turn the heatbed upside down.
[* yellow] Place the M3nN nut on the top of the M3 screw and tighten it slightly.
[* orange] Turn the heatbed back, using pliers and Allen key tighten the screw. We need to adjust cable position in the next step, '''therefore do not tighten the screw too firmly'''.
[* black] Repeat this procedure for the second (red) wire.

Image 1

No previous image

Added

Image 2

No previous image

Added

Image 3

No previous image

Added