Skip to main content

Changes to Step #4

Edit by Dozuki System

Edit approved by Dozuki System

Deleted
Added
Unchanged

Step Lines

[title] Heatbed cable assembly (part 3) [Tłumaczenie w toku]
[* icon_caution] Before proceeding further, please check again the cable is connected correctly to the heatbed.
[* green] '''BLACK''' wire must be connected to the '''"GND"'''
[* red] '''RED''' wire must be connected to the '''"VCC"'''
[* orange] The cable cover, which will be applied later requires the connectors to be slightly inclined towards each other. Press them gently, but leave a gap between them.
[* icon_note] Design of your heatbed might slightly differ from the last picture.
[* black] Now, tighten both screws using the Allen key and the pliers.

Image 1

No previous image

Added

Image 2

No previous image

Added

Image 3

No previous image

Added