Skip to main content

Changes to Step #6

Edit by Dozuki System

Edit approved by Dozuki System

Deleted
Added
Unchanged

Step Lines

[title] Preparing the heatbed-cable-cover [Tłumaczenie w toku]
[* green] Insert M3n nuts in the printed part.
[* red] In case you can't press the M3n nut in, don't use excessive force. Take the M3 bolt and thread it from the opposite side of the printed part, as you tighten the screw, it will pull the nut in. Be careful not the break the printed part during tightening.
[* icon_note] In case the power cable is fixed by screws (not soldered) the heatbed-cable-cover slightly differs from the picture, but the following assembly process is identical.

Image 1

No previous image

Added

Image 2

No previous image

Added

Image 3

No previous image

Added