Skip to main content

Changes to Step #8

Edit by Dozuki System

Edit approved by Dozuki System

Deleted
Added
Unchanged

Step Lines

[title] Proper cable management [Tłumaczenie w toku]
[* icon_caution] Do not stretch the black/white thermistor cable, leave some slack under the heatbed, so when the heatbed moves during print, the cable won't get stretched resulting in disconnection from the centre of the heatbed.
[* icon_caution] However, the slack shouldn't be causing the cable to sag down more than few millimetres. Otherwise, the cable might rub against the printer's frame and damage itself! Turn the heatbed upside-down to check this.
[* light_blue] Guide the black thermistor cable next to the heatbed heater cable and wrap it few times around (see the photo).
[* icon_note] The thermistor cable is in black or white colour, their functionality is the same.

Image 1

No previous image

Added

Image 2

No previous image

Added

Image 3

No previous image

Added