Skip to main content

Changes to Step #10

Edit by Dozuki System

Edit approved by Dozuki System

Deleted
Added
Unchanged

Step Lines

[title] Securing the sleeve in place [Tłumaczenie w toku]
[* blue] Place second part of the cover on the top of the textile sleeve.
[* icon_caution] Make sure the thermistor cable is in the middle going through a cutout in the printed part!!! '''Otherwise, you will pinch and possibly break the cable!!!'''
[* orange] Insert two screws M3x10 and tighten them, proceed with caution and tighten both screws equally.
[* icon_caution] Don't tighten the screw completely on one side and then on the other (see the second picture)!
[* green] Your tightened cover should look like the last picture.

Image 1

No previous image

Added

Image 2

No previous image

Added

Image 3

No previous image

Added