Skip to main content

Changes to Step #17

Edit by Dozuki System

Edit approved by Dozuki System

Deleted
Added
Unchanged

Step Lines

[title] Checking the hotend cables [Tłumaczenie w toku]
[* black] Let's make sure the cables from the hotend aren't in contact with the heatbed.
[* green] Lower manually the X-axis down until the nozzle is almost touching the heatbed.
[* violet] In case the P.I.N.D.A. sensor touches the bed before the nozzle, move it up slightly.
[* icon_caution] Ensure there is a gap between the screw in the heatbed and the surface of the hotend cables. The gap should be 2-3 millimetres, the steel sheet will add another 1 mm.
[* icon_note] In case the cables are rubbing against the screw, adjust them (push them up in the extruder)

Image 1

No previous image

Added