Skip to main content

Changes to Step #8

Edit by Dozuki System

Edit approved by Dozuki System

Deleted
Added
Unchanged

Step Lines

[title] Assembling the X-axis belt (part 3, new design) [Traduction en cours]
[* green] Before you continue to guide the belt through the X-axis, please release two M3 screws on the X-end.
[* yellow] Rotate the X-axis motor as indicated towards the frame.
[* orange] Insert the flat part of the X-GT2 belt into the X-carriage as in the second picture.
[* icon_note] Use a screwdriver or the smallest Allen key to push the belt in.
[* icon_caution] There will be belt overhang on this side, '''DON'T TRIM IT''' yet.

Image 1

No previous image

Added

Image 2

No previous image

Added