Skip to main content

Changes to Step #11

Edit by Dozuki System

Edit approved by Dozuki System

Deleted
Added
Unchanged

Step Lines

[title] Testing the X-axis belt (new design) [Traduction en cours]
[* black] Use the technique described below to test if the belt is properly stretched.
[* violet] Use pliers to hold the X-axis motor shaft.
[* blue] Move the X-carriage towards the X-axis motor. Don't use excessive force.
[* black] If the belt is stretched properly, you should feel a resistance and the X-carriage won't move at all. If the belt is too loose, it will deform (create a "wave") and jump over the teeth on the pulley.
[* icon_note] Belt too loose? Return to step 8 and repeat all steps until now. You have to rotate the motor and retighten the belt in the X-carriage. Shortening the belt length by moving one or two teeth outside X-carriage should be enough.

Image 1

No previous image

Added