Skip to main content

Changes to Step #12

Edit by Dozuki System

Edit approved by Dozuki System

Deleted
Added
Unchanged

Step Lines

[title] Trimming the X-axis belt (new design) [Traduction en cours]
[* black] For the following step we recommend getting a white marker, but you can also trim the belt without it.
[* green] Measure the part, which must be trimmed and gently take the end of the belt away, from the X-carriage, but make sure at least 3-4 teeth are still in the X-carriage, as you don't want to lose the tension. If possible make a mark, where to cut the belt.
[* orange] Ensure again your mark is in the correct position and the belt is still stretched.
[* light_blue] Using pliers cut the belt and push it inside X-carriage. Use screwdriver or Allen key, if needed.
[* black] Ready? Please jump to step [guide|696|Step 19]

Image 1

No previous image

Added

Image 2

No previous image

Added

Image 3

No previous image

Added