Skip to main content

Changes to Step #15

Edit by Dozuki System

Edit approved by Dozuki System

Deleted
Added
Unchanged

Step Lines

[title] Assembling the X-axis belt (part 3, old design) [Traduction en cours]
[* green] Before you continue to guide the belt through the X-axis, please release two M3 screws on the X-end.
[* yellow] Rotate the X-axis motor down.
[* red] Insert the flat part of the X-GT2 belt into the X-carriage as in the second picture.
[* violet] Press the belt all the way in, use a screwdriver or an Allen key.
[* icon_note] There can be a slight belt overhang on this side, no need to trim it.

Image 1

No previous image

Added

Image 2

No previous image

Added

Image 3

No previous image

Added