Skip to main content

Changes to Step #16

Edit by Dozuki System

Edit approved by Dozuki System

Deleted
Added
Unchanged

Step Lines

[title] Tensioning the X-axis belt (old design) [Traduction en cours]
[* blue] Using right hand rotate the motor to its original position and hold it.
[* violet] Using a finger on your left hand push the belt down. Some force should be needed for bending the belt, BUT don't try to overstretch the belt as you might damage the printer.
[* icon_note] If you are struggling to rotate the motor back into position the belt tension is too high.
[* black] Depending on the belt being under or overstretched, adjust the amount of the belt in the X-carriage.
[* green] When done, rotate the motor to its original position and tighten the M3 screws again.

Image 1

No previous image

Added

Image 2

No previous image

Added