Page 1 of 2
I see bolts through the nuts, suggesting that we were to mount the RAMBo board inside the base. Missing step here.
Looking at these and the next photos I realized the green instruction means slide the wrap along the cable holder, not onto it. Tiny point.
The heads on these two zip ties interfered with the left frame side or the Rambo box when I was calibrating. I suggest turning them around so the heads are on the other side.
My long one is 510 mm, my short one is 300 mm.
I had a helper push on the hex nut with a long bolt head while I screwed in the 25mm bolt. That helped.
I didn't realize the motors were differently marked until I discovered, assembling my X-Axis, that I had installed my X Motor here. Instructions are clear for the X-Axis, could be made clear here, too.
May we trim the zip ties at this point? (I don't see tails in the subsequent photos.)
Successfully completed 6. Electronics.
@ 04:19:06 PM
Wrote comment "6. Electronics".
@ 03:00:14 PM
Successfully completed 5. Heatbed assembly.
@ 12:46:54 PM
Successfully completed 4. E-axis assembly (spiral wrap).
@ 10:24:34 AM
Wrote comment "4. E-axis assembly".
@ 09:43:29 AM
Successfully completed 3. X-axis reassembly.
@ 02:00:31 PM
Successfully completed 2. Disassembly.
@ 01:09:43 PM
Successfully completed 1. Introduction.
@ 08:17:23 PM
Wrote comment "5. Extruder Assembly".
@ 08:38:33 AM
Successfully completed 8. Electronics assembly.
@ 07:25:55 PM
Successfully completed 7. PSU & Heatbed assembly.
@ 05:07:58 PM
Successfully completed 6. LCD assembly.
@ 03:19:14 PM
Successfully completed 5. Extruder Assembly.
@ 02:45:08 PM
@ 02:32:38 PM
@ 08:38:09 PM
Successfully completed 4. Z-axis assembly.
@ 07:55:32 PM
Successfully completed 3. X-axis assembly.
@ 03:33:08 PM
Wrote comment "2. Y-axis assembly".
@ 01:57:16 PM
Successfully completed 2. Y-axis assembly.
@ 12:41:44 PM
@ 11:55:34 AM
Once they have, you'll be able to view a graph of their reputation gained over time.
Here's a preview of what the graph will look like:
No reputation gained yet.