Great. Bought a prebuilt printer to avoid having to mess with the RAMBo cover and the 100000 cables so everything fits together without pinching wires or bending pins when closing it, and now I have to disassemble it completely to install a Raspberry Pi :/
I’m just going to connect a normal Raspberry Pi with an USB cable for now I guess :)
How do you know what Rambo board you have?
Had to make the holes slightly bigger on 2 of the 4 pieces
Same remark here
Same comment. Box too small or too much cable
Easiest solution: drill out all the holes and replace the m3x10 by m3x12. These x10 are too short imo
I had to sand the bottom part of the y splitter to make it fit, and cut a small part of the tube. The sanding was done not on the part that touches the hot end, but on the bottom part halfway down. Even without the tube the y splitter wouldn’t fit as the holes didn’t line up
I didn’t get any steel tubes. Moreover my Y splitter looks completely different. It has these blue extensions sticking out of it. Those steel tubes aren’t on the image on the bag either. Well, technically they are but someone put a white sticker over them. I guess this is some kind of upgrade?
I didn’t receive any steel tubes in my kit. The bag that is supposed to contain them contains the steel tubes image on the packaging but there is a white sticker over that image, as to mark that they should not be included. I didn’t see them in any other bag. What’s up with that?
I had to sand the bottom part of the Y splitter (not the part near the hot end, the one halfway down) in order for it to fit, and cut a small part of the tube. Even without the tube the holes didn’t line up and it was impossible to put a screw in.
Once they have, you'll be able to view a graph of their reputation gained over time.
Here's a preview of what the graph will look like:
No reputation gained yet.