Customer Support (eng, fr, cz)
That is absolutely correct.
Did you check all of the bags and boxes? If the parts are really missing, take a photo of the parts you did receive, send them in an an email and we’ll help you out. : )
Hello , thanks for the comment, we’ll check the tolerances.
Dobrý den, děkujeme, opravíme.
No there definitely should not be any gap, please check the cables and the zip ties on the bearings.
Please go through this article, it contains a lot of information on how to troubleshoot this. https://help.prusa3d.com/article/bysrimn...
Technically it could, but the wire would be in the way and you would have to pass it in between the belts so we consider this easier.
Hey Daniel, sometimes the hole is too tight. If that is your case, you might make the wire end thicker by wrapping it in a piece of duck tape.
Yes, at the end, the belt should fit in as shown on the third photo.
The tip on the nylon wire is made so that it would be easier to insert it into the slot. If you, however, use the blunt end instead, it’S not a big deal. Important is that the nylon holds in the printed part.
Page 1 of 69