The instructions should highlight the routing of the extruder motor wires, directing the assembler to ensure they feed through the channel next to the fan.
I snapped a small part of the X-carriage off while doing this. The X-carriage swings away from the lower rod and bearing. I pressed it back in place but the bearing had moved to the right. This slight pressure snapped off part of the horizontal piece that is supposed to hold the bearing in place.
Wrote comment "Re: Problem with trapezoidal nut".
@ 02:02:37 PM
Successfully completed 9. Preflight check.
@ 06:52:08 AM
Wrote comment "5. E-axis assembly (textile sleeve)".
@ 03:05:21 PM
Wrote comment "4. Z-axis assembly".
@ 01:02:27 PM
Once they have, you'll be able to view a graph of their reputation gained over time.
Here's a preview of what the graph will look like:
No reputation gained yet.